Encoder source settings and configuration

From a browser on any device on the same trusted LAN, open http://ENCODER_IP:8080/. The Android Encoder app hosts the input software; use this browser page for routine configuration. Set a clear name/location, supported source type and control address, controller URL, and applicable XMLTV identifiers. The controller URL must include :8081.

For HDMI, attach a compatible UVC USB capture device. Without a dongle, Advanced Settings → Input Source offers Video File and direct HTTP(S) Video URL. Uploading and applying a file sets the connected-device association to Video File automatically; a configuration backup does not include that media file. URL playback depends on Android media and codec support. Neither file nor URL input supplies primary audio.

The Android Encoder can also use a compatible HDHomeRun tuner over the network without an HDMI dongle. In encoder settings, associate the source with HDHomeRun, enter the device IP and a tuner number, then tune an available channel. Reception and audio/video format support depend on the tuner, channel, and Android device. Protected channels may not play. Select Map Channels inside the EPG to open the channel mapper.

In the paid Overlay Editor, the fixed Video layer also offers the primary source controls and placement. Source changes are separate from draft layout edits. Use Media Manager for overlay images and videos; design exports contain their references, not the uploaded files.

The Encoder contacts the overlay subscription server no more than once every 24 hours, including failed attempts. Opening the editor or restarting does not reset that interval.

Changing native capture settings can restart capture. Metadata-only changes need not interrupt the stream. Export supported configuration before major changes. Restore only a configuration supported by the Android version; unsupported restores should fail explicitly.

See equipment, quality, control, and xmltv.


Knowledge home | Getting started | Ask in Discord