Source control: DIRECTV, Xumo, and USB IR

Use only provider-authorized equipment and commercial content rights. A distribution app does not create programming entitlements.

For supported network-controlled sources, configure the correct device type and local IP and enable the provider/device's local-control option where available. Test tuning separately from HDMI capture.

For Android encoder USB IR, use the supported TView transmitter and approve Android USB access. It is send-only. Choose either the network control address or USB IR, not both. Leave the connected-device IP blank for USB IR. The Xumo profile is bundled; installing other supported IR profiles can require internet.

Some devices can be controlled directly over the network, so neither encoder USB IR nor a network IR blaster is universally required. Xumo cannot be controlled by IP in this workflow; encoder USB IR is the preferred option for its source. For another device, such as a TV without supported IP control, a compatible controller-discovered Broadlink network IR blaster may be needed or preferred. Each option has different placement, device, and code requirements; see IR accessories and network remotes.

You can instead keep using a source's handheld remote without DisplayHUB-integrated control. The equipment shopping list builder helps estimate optional control accessories.

An additional source-control accessory is also available; check the listing and its compatibility with your equipment before purchasing. Hardware links may earn DisplayHUB an affiliate commission at no extra cost to you.

The Android Encoder can use a compatible HDHomeRun tuner over the network without an HDMI capture dongle. Configure its association, IP address, and tuner in encoder settings, then tune an available channel. Reception and format support depend on the tuner, channel, and Android device.

See equipment, settings, and epg.


Knowledge home | Getting started | Ask in Discord