DisplayHUB / Knowledge wiki
This is an old revision of the document!
Table of Contents
Android encoder setup
Capture one HDMI source
Use a dedicated ARM64 Android 8+ device with USB host/OTG and hardware H.264. A hub's HDMI output is not an HDMI capture input.
- Connect authorized HDMI source → UVC capture dongle → hub data port → Android device.
- Connect the charger to the hub's charging input.
- Install the signed Encoder APK.
- Open DisplayHUB Encoder and grant the required camera, selected audio, notification, and USB permissions.
- Choose Always open DisplayHUB for the capture device when offered.
- Permit background operation and optionally choose DisplayHUB as the Home app.
- Complete setup, then manage at
http://ENCODER_IP:8080/.
The controller is discovered on the LAN. Verify its saved address includes :8081. Start at 720p30 and 4,000 kbps. Capture starts when the configured app opens; there is no normal browser Start/Stop workflow.
Check before unattended use
Test USB audio, sustained charging balance, temperature, screen-off operation, first unlock after restart, and recovery after USB/network interruptions. Some Android devices still need you to reopen the app or approve USB access. An empty battery does not guarantee automatic power-on after charging resumes.
Supported capabilities
USB HDMI capture, hardware H.264, AAC/HLS, Opus/WebRTC, and layered overlays are supported. Capture modes depend on USB and hardware codec capabilities. File/network primary input, SRT, and board-specific maintenance are not Android encoder features. Protected HDMI may not be capturable; no content-protection bypass is provided.
Normal production updates retain settings and require Android installation approval. Update details.
Read-only public knowledge base, maintained through the site's deployment files. Powered by DokuWiki. Device and firmware behavior must be qualified on your actual equipment.
Start here