DisplayHUB / Knowledge wiki

Blank screens, audio dropouts, delay, and synchronization

Work from source to screen

  1. Confirm the source has authorized content and a valid HDMI output.
  2. Check the encoder's program preview and capture state.
  3. Verify controller/encoder addresses and ports.
  4. Confirm the player app is installed, open, paired, and reachable.
  5. Test one player and one source before a full-room assignment.

Stutter or missing audio

Reduce to 720p30 and moderate bitrate. Prefer wired networking. Check USB audio permission and the configured audio source. If low-latency playback overwhelms a device, try buffered HLS where available or choose stronger hardware.

Timing differences

Roku uses buffered HLS and can be several seconds behind. Nudge can align playback but does not remove its buffer. Do not expect mixed playback modes to match frame-for-frame. Measure on the actual screens and audio system.

Source problems

Protected HDMI may not be capturable. DisplayHUB does not bypass content protection. Contact the source provider for authorized output/distribution options.

When requesting support, include device/app versions, target and actual encoder settings, exact error messages, and reproducible steps. Never post credentials or copyrighted programming.


Knowledge home | Getting started | Ask in Discord

Read-only public knowledge base, maintained through the site's deployment files. Powered by DokuWiki. Device and firmware behavior must be qualified on your actual equipment.