DisplayHUB / Knowledge wiki
This is an old revision of the document!
Table of Contents
Build your first Android setup
Plan the three roles
Use just one Android controller per location. Start with one separate Android encoder input and add as many HDMI inputs as you need as your network allows. Install a supported player per screen. Do not combine roles on a device.
Install the controller
Use an ARM64 Android 9+ device on reliable power. Install the signed Controller APK, open it, allow notifications, and permit background operation. First launch prepares the bundled runtime and can take several minutes.
Open http://displayhub.local:8081/ from the same trusted LAN, or use http://CONTROLLER_IP:8081/. Keep the port. Reserve its IP in your router. See controller.
Connect one encoder
Use an ARM64 Android 8+ device with USB host support, hardware H.264 encoding, compatible UVC capture, USB audio if required, and a powered hub that supports simultaneous data and charging. Install the Encoder APK and complete the on-device permissions. See equipment and encoder.
Open http://ENCODER_IP:8080/. Confirm the controller address includes :8081. Start with 1080p30 (Full HD) at approximately 6,000 kbps when supported. Lower quality if the network or a player struggles.
Install a player and prove the path
Follow players, install the correct player app, and accept pairing prompts on the actual screen. Assign one source to one screen. Check video, sound, delay, charging, and heat before expanding.
Never expose the controller or encoder management ports to the public internet. Confirm commercial viewing and distribution rights with your source provider.
Read-only public knowledge base, maintained through the site's deployment files. Powered by DokuWiki. Device and firmware behavior must be qualified on your actual equipment.
Start here