DisplayHUB / Knowledge wiki
This is an old revision of the document!
Table of Contents
DisplayHUB Encoder Aio
Controller-free encoder mode
DisplayHUB Aio runs on the Android Encoder without a DisplayHUB Controller. The Encoder discovers compatible DisplayHUB Android decoders on the same local network and starts playback automatically when both the Encoder stream and a decoder are ready. Decoders do not consume the regular controller subscription's registered-device seats.
Use a trusted local network that allows device-to-device communication and UDP broadcast discovery. Guest Wi-Fi, client isolation, VLAN rules, or firewalls can prevent discovery or playback.
Set up Aio
- Connect the HDMI source, USB capture device, and Android Encoder. Grant the Android camera, audio, USB, and notification permissions required by the selected input.
- Open the Encoder configuration page from a browser on the same network.
- Open Aio Settings, enter the subscription ID for an active or trialing DisplayHUB Aio plan, and activate it.
- The Encoder starts its configured input when Android permissions and input settings allow it. Compatible decoders on the local network are discovered and sent the live stream.
An Aio subscription is separate from a regular controller subscription. Aio plans are not valid for ordinary controller playback; use the Switch to controller mode option before moving to a controller-based installation.
Stream delivery
By default, Aio uses WebRTC delivery. Enable Only send the HLS compatibility stream when a decoder or network requires HLS. HLS can add more playback delay than WebRTC.
Keep the Encoder and decoders powered and connected to the same routable LAN. Aio discovery runs only while Aio mode is enabled. A decoder that becomes available after startup is discovered automatically.
Encoder features
The Encoder's local input, USB IR, and compatible HDHomeRun tuner controls remain available. The HDHomeRun guide is provided locally by the Encoder. For XMLTV, configure a Guide ID and API key in Advanced Settings; Aio downloads and caches the guide directly on the Encoder, without a Controller. Other centralized device-management features still require a Controller.
The Encoder can switch to controller mode without a separate installer. Google Play billing is not currently supported for Aio; follow the billing option shown for the subscription.
Android encoder setup | Android controller setup | Knowledge home
Read-only public knowledge base, maintained through the site's deployment files. Powered by DokuWiki. Device and firmware behavior must be qualified on your actual equipment.
Start here